This page was exported from Latest Lead2pass Dumps For Sharing [ https://www.ensurepass.net ]

Export date:Wed Jan 22 0:26:06 2025 / +0000 GMT

___________________________________________________


Title: [Lead2pass New] 100% Pass Lead2pass 300-101 New Questions Free Version (321-340)

---------------------------------------------------


2017 October Cisco Official New Released 300-101 Dumps in Lead2pass.com!  100% Free Download! 100% Pass Guaranteed!  I'm currently studying for Cisco exam 300-101. I do enjoy studying for exams. It's hard, but it's an excellent forcing function. I learn bits and pieces here and there now and then about this and that, but when I have an exam schedule for a set date, I have to study! And not only do I put in more hours, but I follow a more systematic approach. In this article, I'm going to share Lead2pass braindumps in case you too are studying and this method works for you. Following questions and answers are all new published by Cisco Official Exam Center: https://www.lead2pass.com/300-101.html  QUESTION 321Which command sequence can you enter a router to configure Unicast Reverse Path Forwarding in loose mode? A.&nbsp;&nbsp;&nbsp; interface GigabitEthernet0/0ip verify unicast source reachable-via loose.B.&nbsp;&nbsp;&nbsp; interface GigabitEthernet0/0ip verify unicast source reachable-via all.C.&nbsp;&nbsp;&nbsp; interface GigabitEthernet0/0ip verify unicast source reachable-via any.D.&nbsp;&nbsp;&nbsp; interface GigabitEthernet0/0ip verify unicast source reachable-via rx.Answer: C QUESTION 322Refer to Exhibit. R1 is unable to ping interface S0/0 of R2.What is the issue the configuration that is shown here? &nbsp; A.&nbsp;&nbsp;&nbsp; The route-target configuration command is missing.B.&nbsp;&nbsp;&nbsp; The interface IP addresses are not in the same subnet.C.&nbsp;&nbsp;&nbsp; the syntax of the ping command is wrong.D.&nbsp;&nbsp;&nbsp; The default route configuration is missing.E.&nbsp;&nbsp;&nbsp; The serial interfaces belong to the global table instead of vrf Yellow. Answer: E QUESTION 323A router was configured with the eigrp stub command.The router advertises which types of routes? A.&nbsp;&nbsp;&nbsp; connected, static, and summaryB.&nbsp;&nbsp;&nbsp; static and summaryC.&nbsp;&nbsp;&nbsp; connected and staticD.&nbsp;&nbsp;&nbsp; connected and summary Answer: D QUESTION 324In which scenario can asymmetric routing occur? A.&nbsp;&nbsp;&nbsp; active/active firewall setupB.&nbsp;&nbsp;&nbsp; single path in and out of the network.C.&nbsp;&nbsp;&nbsp; active/standby firewall setupD.&nbsp;&nbsp;&nbsp; redundant routers running VRRP Answer: A QUESTION 325Which two types of threshold can you configure for tracking objects? (Choose Two) A.&nbsp;&nbsp;&nbsp; percentageB.&nbsp;&nbsp;&nbsp; MTUC.&nbsp;&nbsp;&nbsp; bandwidthD.&nbsp;&nbsp;&nbsp; weightE.&nbsp;&nbsp;&nbsp; delayF.&nbsp;&nbsp;&nbsp; administrative distance Answer: AD QUESTION 326The network engineer types the follow commands in a router: logging host 172.16.10.12logging trap 5 What do these commands do? A.&nbsp;&nbsp;&nbsp; Export messages of notifications for an external serverB.&nbsp;&nbsp;&nbsp; Show notifications in cliC.&nbsp;&nbsp;&nbsp; Sends info to host 172.16.10.12 with notifications less than or equal to 5D.&nbsp;&nbsp;&nbsp; Sends info to host 172.16.10.12 with notifications greater than or equal to 5 Answer: C QUESTION 327A network engineer executes the show ip sla statistics command.What does the output of this command show? A.&nbsp;&nbsp;&nbsp; Operation availabilityB.&nbsp;&nbsp;&nbsp; device CPU utilizationC.&nbsp;&nbsp;&nbsp; interface packet statistics.D.&nbsp;&nbsp;&nbsp; packet sequencing Answer: A QUESTION 328Drag and Drop QuestionDrag and drop the IPv6 NAT characteristic from the left onto the correct IPv6 NAT category on the right. &nbsp; Answer:  &nbsp; QUESTION 329What are characteristics of PAP and CHAP?(choose two) A.&nbsp;&nbsp;&nbsp; PAP provides a challenge to the clientB.&nbsp;&nbsp;&nbsp; CHAP provides a challenge to the clientC.&nbsp;&nbsp;&nbsp; PAP can be used by TACACS+ for withD.&nbsp;&nbsp;&nbsp; PAP requires a username and optional passwordE.&nbsp;&nbsp;&nbsp; CHAP requires a username and optional password Answer: BC QUESTION 330Which three NTP operating modes must the trusted-Key command be configured on for authentication to operate properly? (Choose Three) A.&nbsp;&nbsp;&nbsp; interfaceB.&nbsp;&nbsp;&nbsp; clientC.&nbsp;&nbsp;&nbsp; peerD.&nbsp;&nbsp;&nbsp; serverE.&nbsp;&nbsp;&nbsp; broadcast Answer: BDE QUESTION 331What does the show ip route vrf CISCO command display? A.&nbsp;&nbsp;&nbsp; directly connected routes for VRF CISCO.B.&nbsp;&nbsp;&nbsp; the routing table for VRF CISCO.C.&nbsp;&nbsp;&nbsp; the global routing table.D.&nbsp;&nbsp;&nbsp; all routing tables that start with VRF CISCO.E.&nbsp;&nbsp;&nbsp; the route distinguisher for VRF CISCO Answer: B QUESTION 332Which two BGP neighbor states are valid? (Choose two) A.&nbsp;&nbsp;&nbsp; establishedB.&nbsp;&nbsp;&nbsp; activeC.&nbsp;&nbsp;&nbsp; stuck in activeD.&nbsp;&nbsp;&nbsp; 2-WAYE.&nbsp;&nbsp;&nbsp; unknownF.&nbsp;&nbsp;&nbsp; DROTHER Answer: AB QUESTION 333Where the output will be shown of the command debug condition interface fa0/1? A.&nbsp;&nbsp;&nbsp; it will show on interface f0/1B.&nbsp;&nbsp;&nbsp; it will show on interface f0/0C.&nbsp;&nbsp;&nbsp; both interfaces will show debugging outputD.&nbsp;&nbsp;&nbsp; an interface cannot be used as condition Answer: A QUESTION 334Which command is used to check IP SLA when an interface is suspected to receive lots of traffic with options? A.&nbsp;&nbsp;&nbsp; show trackB.&nbsp;&nbsp;&nbsp; show threshold Answer: A QUESTION 335Engineer has to enable RIP on a link. Where he will issue the command? A.&nbsp;&nbsp;&nbsp; Ipv6B.&nbsp;&nbsp;&nbsp; GlobalC.&nbsp;&nbsp;&nbsp; Router sub commandD.&nbsp;&nbsp;&nbsp; Interface subcommand Answer: C QUESTION 336A route map was configured and it was distributing OSPF external routes. A.&nbsp;&nbsp;&nbsp; Distributing E1 onlyB.&nbsp;&nbsp;&nbsp; Distributing E1 and E2 using prefix listC.&nbsp;&nbsp;&nbsp; Distributing E1 and E2 using access listD.&nbsp;&nbsp;&nbsp; Distributing E2 routes Answer: B QUESTION 337Which routing protocol does DMVPN support? (Choose three) A.&nbsp;&nbsp;&nbsp; ISISB.&nbsp;&nbsp;&nbsp; RIPC.&nbsp;&nbsp;&nbsp; EIGRPD.&nbsp;&nbsp;&nbsp; OSPFE.&nbsp;&nbsp;&nbsp; BGP Answer: CDE QUESTION 338What is the reasons of command: router(config)# snmp-server host 192.168.1.3 traps version 2c CISCORO A.&nbsp;&nbsp;&nbsp; for network system to management serverB.&nbsp;&nbsp;&nbsp; allow 192.168.1.3 only Answer: A QUESTION 339Option invalid redistribute from EIGRP into OSPF A.&nbsp;&nbsp;&nbsp; ACLB.&nbsp;&nbsp;&nbsp; tagC.&nbsp;&nbsp;&nbsp; metricD.&nbsp;&nbsp;&nbsp; route map Answer: A QUESTION 340Which location is traffic from IP SLAs? A.&nbsp;&nbsp;&nbsp; core edgeB.&nbsp;&nbsp;&nbsp; access edgeC.&nbsp;&nbsp;&nbsp; WAN edgeD.&nbsp;&nbsp;&nbsp; Distribution edgeE.&nbsp;&nbsp;&nbsp; User edge Answer: C If you want to prepare for 300-101 exam in shortest time, with minimum effort but for most effective result, you can use Lead2pass 300-101 dump which simulates the actual testing environment and allows you to focus on various sections of 300-101 exam. Best of luck! 300-101 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDX0QwYXF1aXFINmM  2017 Cisco 300-101 exam dumps (All 470 Q&amp;As) from Lead2pass:  https://www.lead2pass.com/300-101.html [100% Exam Pass Guaranteed]

---------------------------------------------------


Images: 

---------------------------------------------------




---------------------------------------------------


Post date: 2017-10-17 07:03:16

Post date GMT: 2017-10-17 07:03:16

Post modified date: 2017-10-17 07:03:16

Post modified date GMT: 2017-10-17 07:03:16



____________________________________________________________________________________________


Export of Post and Page as text file has been powered by [ Universal Post Manager ] plugin from www.gconverters.com